New!!!

FMA Cellpro PowerLab 8

FMA Cellpro PowerLab 8 Charger

Qty: Combo: Charger (No Adapters) $250.99 Combo 1(With 1 - TP/PQ ADAPTERS) $270.99 Combo 2 (with 1 - JST/GP Adapter) $270.99 Combo 3 ( with 2 - TP/PQ adapters) $300.99 Combo 4 (with 2 - JST/GP adapters) $300.99

 

Features:

• Charge, discharge, monitor, and perform multiple cycles
• Log and Graph all major operations when using free Charge Control Software (CCS)
• Support for all current and future battery chemistries
• Selectable charge rates range 10mA to 30A
• Selectable discharge rate range 10mA to 10A/30A (ext discharge)
• Charge power rating, 1008W @ +24VDC input voltage, 516W @ +12VDC input voltage
• Discharge power rating 100W (internal), 1000W (external regenerative), see illustration below
• Smart power management protects input supplies
• Node-only operation option available

 

For Battery types:

• Lithium Polymer (1s to 8s balanced, 1s to 2s unbalanced)
• Lithium Ion (1s to 8s balanced, 1s to 2s unbalanced)
• Lithium Manganese (1s to 8s balanced, 1s to 2s unbalanced)
• A123 (LiFePO4) (1s to 8s balanced, 1s to 10s unbalanced),
• NiCd (1s to 21s), NiMH (1s to 21s)
• 6v, 12v, 24v Lead Acid batteries (Flooded, Gel, AGM, SLA)

Pack capacity:

20 mAh to 360Ah

Input voltage:

10-32VDC, reverse polarity protected

Input current:

1A to 60A, software limited

Power conversion:

Synchronous DC/DC converter, supports multiple switcher frequencies of 31.25 kHz, 62.5 kHz, 125 kHz; user selectable by preset, 85% to 93% efficiency depending on output current

Output battery charge current:

Adjustable range 10mA to 40A, limited by 60A input current*

Output battery discharge current:

Internal discharge 10mA to 10A, 100W max Regenerative discharge 10mA to 40A, 1344W max**

Continuous max output power:

612W @ +12VDC input, 1344W @ +26.35VDC
Cell balancing: Resolution 78uV (16 bit) for 1s-8s Li or A123 (LiFePO4) balanced charging

Voltage calibration:

Cell voltage measurements are factory calibrated to a standard traceable to NIST; calibration is to +/- 6 mV

Current calibration:

Charge current is factory calibrated on a 4A standard; calibration is to +/- 1mA

Measurement accuracy:

• Voltage resolution: 78uV (16 bit)
• Voltage tolerance: +/- 6mV
• Charge current: +/- 1%
• Capacity added to pack: +/- 1%
• Percent capacity ("Fuel"): +/- 5% (with accurate fuel table defined for battery being charged)

Serial data output:

19.2kbps, 8 bits, 1 start bit, 1 stop bit, no parity

Data integrity:

Checksum, CRC checking

Cooling fans:

Twin, 13 CFM, 50mm diameter

Heat sink:

Internal 200W aluminum, thin finned

Output battery connector:

"Cellpro" compatible, JST PA series, 9 position

LCD:

2 line, 16 character, light grey/blue backlit